Replies – Forums – Jill Abrahams

Forum Replies Created

Jill Abrahams
September 16, 2009 at 10:24 pm in reply to: transitions

Ouch. I guess I should have said DVD Pro, though I thought I was in a specific DVD Pro forum so it was understood.
Jill Abrahams
September 16, 2009 at 4:14 pm in reply to: Lost Footage

Thanks guys! I really appreciate your help. I can capture the footage, but when I proceed after the warning, it doesn’t match up. Maybe I’ll try again with a different set of tapes on another part of the project.
Jill Abrahams
September 16, 2009 at 1:28 am in reply to: Lost Footage

Ah ha, makes sense. Thank you.

Arg!!
Jill Abrahams
September 15, 2009 at 11:55 pm in reply to: transitions

Makes sense. Thank you.

(“Their” refers to the program/programmers who created it. heh)
Jill Abrahams
September 15, 2009 at 11:30 pm in reply to: transitions

Thanks Michael! Yes, menus. However, I’ve simply used one of their transitions (“blur”). Would you be able to easily explain how to add a sound effect to that — or is it only when I create my own transitions that I can include audio?
Jill Abrahams
September 15, 2009 at 10:19 pm in reply to: Re-loading Footage

Yes, I did. I know what tapes to load and where to reconnect them. However, because of the setting (new clip with timecode break), each tape resulted in 4 – 5 footage files.

And, it seems unless I capture the exact same section of the tape this time as I did the first time, I get the prompt:

“Some attributes of one or more of the files you have chosen do not match the attributes of the original. This may cause problems within the sequences that are dependent on them. The attributes that differed are as follows:

– Media Start and End

Make sense?

Please advise. Thanks.