Forum Replies Created

  • Jc Of naz

    August 15, 2007 at 3:46 pm in reply to: Loss of Quality on Exporting from Premiere Pro 2

    Thanks again for you assistance. We are just in the middle of doing research on the Canopus ProCoder. Sorry to ask another question that may seem dumb but here goes anyway… We are playing around with the settings in the Media Encoder and we set the profile to High and the level to High Level, then the bit rate allowed us to set it to as high as 100Mb/s. We set the rates to 25 Mb/s for Min., Target, and Max and rendered out a piece and it looked great.(compared to the previously mentioned problem) I haven’t uplinked anything to the distribution center yet as we just found this when you posted. My question I guess is: Is this something that is acceptable for broadcast or am I barking up the wrong tree? Compression has always been a “pressing” issue for us. There seems to be an OVERWHELMING amount of choices and one thing being off can screw things up royally. Thanks for your help yet again.

    JCS

  • Jc Of naz

    August 15, 2007 at 12:06 pm in reply to: Loss of Quality on Exporting from Premiere Pro 2

    Thanks for the help sir. Do you have any suggestions on which encoder might work best for this purpose? Any help would be greatly appreciated.

    JCS

  • Jc Of naz

    August 14, 2007 at 6:44 pm in reply to: Loss of Quality on Exporting from Premiere Pro 2

    Encoding: MPEG-2
    Min: 10Mbs
    Max: 25Mbs (system only goes to 15Mbs)
    Preferred: 25Mbs
    Scanning: 480 60i(upper field first)
    PAR: 0.9
    Aspect Ratio: 4:3
    Chroma-Min: 4:2:0 (MP@ML) (720×480)
    Chroma-Preferred: 4:2:2 (422P@ML) (720×512)
    GOP: All Allowed, IBBP preferred
    FPS: 29.97
    Stream Type: Program Stream
    Luminance Level Max: 100 IRE
    Chroma Level Max: 120 IRE
    Setup Level: 7.5 IRE
    Non-Drop Timecode

    JCS

  • Jc Of naz

    August 14, 2007 at 6:17 pm in reply to: Loss of Quality on Exporting from Premiere Pro 2

    Thank You very much I will try it and keep you posted.

    JCS

  • Jc Of naz

    August 14, 2007 at 5:49 pm in reply to: Loss of Quality on Exporting from Premiere Pro 2

    The durations of the spots range from :05 seconds to :30 seconds.
    The encoding settings are as follows:
    Video Codec Main Concept MPEG Video
    NTSC
    720X480
    29.97 Non-Drop
    Upper Field First (required by DGS Fastchannel)
    standard 4:3
    Quality 5.0
    Profile: Main
    Level: Main
    VBR, 2 pass, Min 10.00, Target 15.00, Max 15.00[Mbps]
    GOP Settings: M-3 N-15 Automatic GOP Placement
    Advanced Settings:
    Macroblock Quantization 10
    VBV Buffer 112
    Noise Control- Sensitivity
    Write SDE- No
    Force VBV delay- Oxffff
    Intra DC Precision 9 bits

    JCS

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy