Replies – Forums – David Ritchie

Forum Replies Created

David Ritchie
May 5, 2020 at 6:54 pm in reply to: Newbie here..Question on multiple cam setup Canon XA50 and Vixia HF200

I THINK have may have figured out part of the problem. Although the B roll camera is set to 24 FPS at its maximum setting of 24 Mbps It is still outputting a 29.97 frames/second. I have gone through the camera and tried resetting it to factory and have tried a 60i frame rate, and a 24P but ehen checking the file it continues to say 29.97. I know they had an issue with these and the firmware in the past, i assume this is part of the issue. I have tried calling Canon service but they tell me this product is no longer supported. So i guess i have a couple of B rolls that can only shoot at 29.97

Canon XA50, Canon HF20, Canon HF200, Adobe CC, Nikon D750, Sony A6000, Zoom H4N,
David Ritchie
May 5, 2020 at 4:28 pm in reply to: Newbie here..Question on multiple cam setup Canon XA50 and Vixia HF200

Thanks for the reply.

I watched it directly out of the camera to monitor via HDMI and its not doing the stuttery look.

I am bringing the footage into post seperately, BUT the vixia gives me several clips at 1.90 GB each. I dropped them on the time line and NESTED them and then made a NEW subsequence from it.. Perhaps i should have merged it all together then Rendered, THEN started the editing process?

What software are you using that tells you that portion of the video is only 12FPS?

Thanks!

Canon XA50, Canon HF20, Canon HF200, Adobe CC, Nikon D750, Sony A6000, Zoom H4N,