Replies – Forums – Chris232

Forum Replies Created

Chris232
November 8, 2007 at 11:02 pm in reply to: NTSC Project – 650×480 instead of 720×480

Thanks Joe thats exactly what was confusing me!
Chris232
November 7, 2007 at 12:18 am in reply to: NTSC Project – 650×480 instead of 720×480

Thanks for the reply. The problem is that everything, not just the menus, but the video too, all appears as 650×480 instead of 720×480 in the project. 720×480 is the proper Ntsc resolution, where as 650×480 is not. How do I see if the menus are set to square pixels? I can’t find anywhere to set this.
Chris232
September 13, 2007 at 9:53 pm in reply to: Auto/Manual Transcoding creating files too big.

Its Encore 1 so very dated however I can’t really afford to upgrade right now. I have it set to single layer 4.7gb dvd everywhere I can find.
Chris232
September 13, 2007 at 8:42 pm in reply to: Auto/Manual Transcoding creating files too big.

Hi Jeff thanks for the reply. I tried reverting to orignal and switching to automatic but the automatic settings would still transcode the video so the final size was over 7gbs, so too big to fit on a DVD.

Running length of the project is close to 2 Hours all up. One 30 minute video and about 20-25 smaller 3 – 10 minute videos across 4 menus.

I reduced the max bitrate on the Pal 4mb 2 Pass preset to 7mbps but still get the error saying data rate is too high.
Chris232
September 13, 2007 at 10:18 am in reply to: Auto/Manual Transcoding creating files too big.

https://kb.adobe.com/selfservice/viewContent.do?externalId=329100&sliceId=2

I have found this, but still get the message even when using Dolby Audio with the ‘PAL DV High Quality 4mb VBR 2 Pass’ preset.

This preset keeps the video under the 4.7GB limit of the disc but doesn’t stop the ‘data rate too high’ message. Any ideas what soever would be helpful, I have had so many problems with this project, hopefully this will be the last one before I can finally get the disc burnt.
Chris232
September 13, 2007 at 5:18 am in reply to: Auto/Manual Transcoding creating files too big.

I have finally mananged to get it to transcode everything under 4.7GB and now I get the error message

‘the data rate of this file is too high for DVD . You must replace the file with one of a lower data rate. (DVD Error -20404)’

when I try and build the DVD. Does anyone know how I can resolve this?
Chris232
September 13, 2007 at 1:09 am in reply to: Butten Routing Problem ( Not the usual one)

Thanks Dave, after spending a few hours in photoshop I mananged to get it sorted.
Chris232
September 9, 2007 at 10:32 pm in reply to: Setting Chapters with multiple video files conundrum.

Thanks for the replys

I was a bit hesitant to add all the .avis to a timeline as I thought another pass through Premiere would degrade the quality.
I don’t know enough about how it works though, would the fact that the .avis haven