Replies – Forums – Ben Scott

Forum Replies Created

Ben Scott
April 18, 2008 at 12:11 pm in reply to: Applying motion blur to each layer or to a top adjustment layer?

Thanks for the speedy response Pete. Will set it off rendering and go shopping I think!

Will post how it goes.

Regards,

Ben
Ben Scott
April 18, 2008 at 12:11 pm in reply to: Applying motion blur to each layer or to a top adjustment layer?

Thanks for the speedy response Pete. Will set it off rendering and go shopping I think!

Will post how it goes.

Regards,

Ben
Ben Scott
August 17, 2006 at 4:14 pm in reply to: Another film-look question – This week, A Scanner Darkly

Hi Peter,

Thanks for your advice.

However, I seem to be crashing Boris whenever I try to use the median filter (among others). May be time for a clean install to get rid of some problematic AE filters and other bits and pieces that seem to be annoying Boris.

Will try as soon as it’s sorted though. Thanks for taking the time to answer.

Ben
Ben Scott
August 17, 2006 at 3:36 pm in reply to: Another film-look question – This week, A Scanner Darkly

Thanks Gary,

I’ll have a play-around with it. Can I just say that they are the best set of filters I have ever owned?

Cheers,

Ben
Ben Scott
July 31, 2006 at 10:34 am in reply to: Sin City Look with Boris Red and Avid XPro?

You are a genius.

Will give this a go at when I get home.

Nice one – thanks matey,

Ben
Ben Scott
July 19, 2006 at 11:31 pm in reply to: Reversing effect in Boris Red preset?

Done. Yey!

Thanks so much for your help.

Ben
Ben Scott
July 19, 2006 at 11:37 am in reply to: Reversing effect in Boris Red preset?

Thanks for getting back to me. Much appreciated. Used a workaround in the interim but will give it a try now today and get back to you.

Regards,

Ben

PS Getting away from the computer? That’s possible? I don’t think I’ve been away from mine since it was a Commodore 64.
Ben Scott
July 14, 2006 at 4:18 pm in reply to: Reversing effect in Boris Red preset?

Hi again,

Now I may be just being exceptionally stupid but when I try to paste the ‘copied’ keyframes onto the end of the sequence they don’t actually show, like they would for example if you CTRL-V pasted a clip in Avid. Almost like they are pasting but just over the original keyframe, no matter where I am in the timeline.

I’m sure this is a really dim question – even dimmer than the last, but how can I paste the entire composition straight after the first on the timeline in order to then reverse? Is there a ‘mark in-point’ button I’ve not yet discovered?

Thanks once again,

Ben
Ben Scott
July 14, 2006 at 2:17 pm in reply to: Reversing effect in Boris Red preset?

You are a lifesaver! Thank you so much. Will try when I get in.