Replies – Forums – Ali-reza Djassemi

Forum Replies Created

Ali-reza Djassemi
March 21, 2017 at 8:05 pm in reply to: How do I have to setup the Render settings for movies on an escelator panel.

Hi Tero, you are absolutly right. I think the playback software is going to be either vlc player or quicktime player. As I made positive experiences already with quicktime I think We will use that player. For the hardware I am not sure yet.
Ali-reza Djassemi
March 21, 2017 at 7:06 pm in reply to: How do I have to setup the Render settings for movies on an escelator panel.

Hi Dave, ???????????? 50% sounds as I might move the world. ????
No, honestly. I appreciated your information because I was able to consider what I have to do if things will be the wrong way.
I might create a final composition where I place all produced compositions into. This one will be with the ‘normal’ ratio (1920 x1080). There I just have to rotate the composition and render it.
Best regards
Ali-reza Djassemi
March 21, 2017 at 7:00 pm in reply to: How do I have to setup the Render settings for movies on an escelator panel.

Hi Tero. Well, actually the target device is a NEC P401. That is all information I received.
Ali-reza Djassemi
March 21, 2017 at 6:13 pm in reply to: How do I have to setup the Render settings for movies on an escelator panel.

Dear Dave,

just to make sure I did understand you the right way. I produce the footage 90 degrees rotated, yes?

Ah, sorry Dave, I actually flipped the ratio, which is not a problematic thing to do, and realised I am able to render high quality footage in quicktime format and quicktime does play it back as is in 1080 x 1920. This was exciting. ????

I have to admit that I did not try to play the movie on the target screen which will be rotated 90 degrees. You think this will be played back the wrong way, right?

Best regards