Replies – Forums – Alexander Znaskevich

Forum Replies Created

Alexander Znaskevich
March 6, 2019 at 2:35 pm in reply to: LTO-7 capacity issue

Hello Tim,

Here are the ATTO Thunderlink SH3128 features:
12Gb/s SAS/SATA Support
Auto Negotiation between 12Gb/s, 6Gb/s and 3Gb/s SAS/SATA devices
Supports Serial SCSI Protocol (SSP), SATA Tunneling Protocol (STP, SMP, SAT and direct attached SATA protocol
SES and S.M.A.R.T. support
Flash ROM for easy field updates
Wide port end device support
Support for SAS tape devices and transport layer retires (TLR) for error handling

I’ve tried again to write my data to new tape with BRU PE, and it’s wrote less than 2TB.
I’d tested my RAID with Blackmagick speed test, and it show write/read speed about 300 MB/s. I have no more ideas.
Alexander Znaskevich
March 4, 2019 at 3:25 pm in reply to: LTO-7 capacity issue

It’s been making strange noise after 3TB like earlier. I will wait little bit more.
Alexander Znaskevich
March 4, 2019 at 3:10 pm in reply to: LTO-7 capacity issue

Hi Tim,
Thank you for your response. I’ve pluged ATTO to left-side port and runned Read/Write test with ‘whole tape’ option (there is 64KB block size by default). It’s wrote already more than 3TB, and it seems ok. Maybe I may to try BRU PE again with block size 64KB (now there is 256KB)? Do you have any ideas?
Alexander Znaskevich
February 28, 2019 at 8:55 pm in reply to: LTO-7 capacity issue

Hi Tim, of course I’ve done all tests and all of them was successful. Also I’ve sent support ticket to HPE support, but they had recommend me to install last StoreOpen. But I have same issue. It writes less then 2 TB, eject the tape and flashing ‘clean’ LED after that.
Alexander Znaskevich
February 21, 2012 at 5:32 am in reply to: DaVinci Resolve Lite problem

sent.
Alexander Znaskevich
February 17, 2012 at 8:25 am in reply to: DaVinci Resolve Lite problem

Yes, FCP is installed. I think, there is problem with dvcpro 1080p25, cause 720p25 works fine.