-
Two Problems with RED 5 and Vegas 11.0
Hi all
I’m trying to use RED 5.0.6 (64bit) as a plug-in for Sony Vegas 11.0. But I have the two following issues:
1. My footage and Vegas project is 720×576 PAL-DV format. However, RED recognizes 786×576 and doesn’t let me change the format. Therefore corrections in RED show in the wrong spot in Vegas (e.g. paint strokes, wire removal).
2. When I work a little in RED, especially when I try to use the stabilization filter or when I move around the timeline a lot, suddenly RED shows the green V1 image instead of the footage from Vegas.
I had a similar problem with an OFX filter that I programmed myself: If Vegas realizes it’s getting too slow it reduces the resolution of the video preview. My filter crashed until I had identified this problem. Could it be that RED shows the green V1 in exactly that situation?Regards,
Stefan -
3 Replies
-
I believe we are aware of both issues with Sony Vegas. We hope to resolve them in the next update.
Boris Yamnitsky
BorisFX -
Noticed same here ( vegas 11 ) PLUS noticed the frame rate in RED being different than in vegas ( both 10 and 11 ).
Am using PAL m2t ( 1440×1080 50i ) but when loaded in red 5 , it plays faster preview as if it plays the American 60i. -
For the moment I found a workaround for this issue: When I want to do motion tracking in Boris RED as a Vegas Plug-in, I close the Vegas video preview window and I hide the timeline. Like that I face fewer problems with RED changing to the green V1 footage.
Is there an estimated release date for the RED update solving these issues?
Best,
Stefan
Reply to this Discussion! Login or Sign Up