-
Please Help! Problem re-establishing sync when switching in and out of capture mode in FCP.
I have recently been having a sync problem when switching in and out of capture mode. When I switch to or from capture I have to turn my Horita BSG-50 sync generator off then on again to reestablish sync. I didn’t used to have this problem.
I’m running Mac version 10.3.8.
FCP version 4.5.
I recently upgraded to Decklink driver 4.8 (not sure if this is the problem).
Newest Quicktime.
Horita BSG-50 sync generator. -
2 Replies
-
Hi Ian,
I’m not sure if your problem is related to the DeckLink 4.8 drivers or not. Can you please try the following pre-release drivers and let me know if they help?
https://www.blackmagic-design.com/downloads/software/seed/DeckLink_Macintosh_v4.8.1b4.zip
Regards,
Luke Maslen
Blackmagic Design -
I tested my system for about 10 minutes so far and your fix worked!
Thanks so much.
I’ll let you know if things change.Ian
Reply to this Discussion! Login or Sign Up