- September 25, 2007 at 11:14 pm
I think I’ll probably have to call Autodesk support in the morning… but by chance does anyone know if the Flame will support Kona down conversion (to NTSC from HD) one of the outputs while putting HD out the other?
probably not…. proprietary linux drives and autodesk nonsense….
- September 26, 2007 at 7:40 pm
I would hope that they would take advantage of everything the board has to offer. We certainly do it on our side of the fence and we are also Linux. Difference is we use our own driver and no nonsense here as our driver supports everything the boards offer 🙂
Best of luck,
Log in to reply.