• Maxon Cinema 4D

  Dynamics: To Set Start & Stop Parameter

  Posted by Mike Jones on January 31, 2009 at 1:06 pm

  Hey

  I have a standard block (rigid body’s) falling onto the floor and I’d like to know how to be able to set a restriction so that I can set when they start their action.

  Basically, I’m doing a stack of cards, and one by one they ‘jump’ off (I used the Start tab and set x parameter and rotation) to reveal the next card underneath.

  I realize I am able to set their state so they all rest on each other but Dynamics is very hard to control so I thought the best way would be able to set when I can start their actual physical motion into the dynamics scene.

  I would essentially have a stack of cards
  Then, One card jumps off top revealing the one below then,
  The card below after 2 seconds gets triggered to actually have the dynamics tag it has and then do the same etc etc.

  Thanks a lot.

  Mike Jones replied 17 years, 3 months ago 1 Member · 0 Replies
• 0 Replies

Reply to this Discussion! Login or Sign Up