Creative Communities of the World Forums

The peer to peer support community for media production professionals.

Forums Compression Techniques Any ideas on how this was done?

  • Any ideas on how this was done?

  • Whitlock Dunbar

    September 1, 2007 at 7:27 pm

    Here’s the link:

    Like the subject line says; does anyone have any ideas on how a video clip of this high quality was compressed for the web? I’m using the CS3 Production Bundle and Squeeze 4. So far I haven’t even come close. Any tips (other than experiment alot) would be great.

  • Craig Seeman

    September 1, 2007 at 10:57 pm

    Start by shooting on 35mm film. Probably compressed with On2VP6 although I’m not sure at what high data rate.

  • Whitlock Dunbar

    September 3, 2007 at 1:52 am

    I’m sorry I should have been clearer. I understand how it was shot, my interest is in how to achieve the clear image quality and smooth motion after compression for the web. I’m using Squeeze and VP6, but based on your response to a similar post, I think I’m being much too conservative with the data rate.

    In my failures thus far I never went above 400 kB/sec, and only varied the Keyframe Frequency and the Minimum Quality settings. The results were always very blocky with stuttery motion. I’ll keep trying…

Viewing 1 - 3 of 3 posts

Log in to reply.

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy