-
10.0.6 deleting off by a frame
I’ve got a new behavior that started when I upgraded to 10.0.6. Setting an In point, moving forward a few frames, setting an Out point, then hitting ‘delete’ does *not* remove the last frame shown as being within the selection, and sets the insertion point *after* that frame. Is anyone else seeing this?
It’s especially a problem editing multicam- I select a range, delete it, hit a number key to switch angles, and end up with a one-frame flash of the original angle after the cut.
-
0 Replies
Sorry, there were no replies found.
Reply to this Discussion! Login or Sign Up