-
Cinema 4D render reverting back to old settings?
I am working on a small project that involves candies falling from the sky. I’ve used one of Greyscalegorillas sets in his HDRI lighting kit. I am rendering a set of frames at a time, and the first 300 or so frames went fine.
After reviewing these sets, I wanted to make some changes to my emitter, basically just increasing the output of the candies. When rendering in the picture viewer it renders what the old settings were, I have checked to make sure that the emitter wasn’t set on some different settings that I might have key=framed and it reverted back to those. I am completely lost on why it is doing this, I did attempt to use the mograph cache tag earlier and ended up deleting it later to make changes. Could this be the issue?
Thanks
-
3 Replies
-
Just a side note:
Restarted both Cinema 4D and my computer.
Created new camera, new emitter, and even new particles(candies).
Saved as a different file and reopened in Cinema 4D.
I do not have access to another computer with 4D on it, to see if the issue follows me there.Thanks again!
-
You’re using a standard emitter? You realize that there are separate birth rate settings for the editor and renderer?
-
Yes, I am using a standard emitter. But I was unaware that there are different birthrate settings for the emitter and render. But I don’t know how these could have changed, it changed when I used a MoGraph Cache tag and then deleted it.
I’ve looked and it’s probably as clear as day, but I cannot find the different birthrate emitter settings.
C4d R11.5 64-bit Windows 7
Reply to this Discussion! Login or Sign Up