• Maxon Cinema 4D

  Sweep along a Spline

  Posted by Lars Wikstrom on September 18, 2007 at 10:28 pm

  Hi, when I try to use the Sweep function to make a hose the image is flat. I was hoping it was going to sweep a circle along the spline which it does, but it make the circle flat on the ground plane so it doesn’t look like a hose.

  What am I doing wrong?

  Thanks,

  -Lars

  Lars Wikstrom replied 18 years, 7 months ago 2 Members · 2 Replies
• 2 Replies

• 

  Adam Trachtenberg

  September 18, 2007 at 11:21 pm

  Sounds like you need to adjust the axis of your circle (profile) spline. The Z axis should be pointing out.
• 

  Lars Wikstrom

  September 19, 2007 at 7:38 am

  Thanks, I will give that a shot.

  -Lars

Reply to this Discussion! Login or Sign Up