Creative Communities of the World Forums

The peer to peer support community for media production professionals.

Activity Forums AJA Video Systems No firewire output on Kona LS

  • No firewire output on Kona LS

    Posted by Easycompany on September 12, 2005 at 7:31 am

    I just got a Kona LS fully updated (v.1.1.3) on a G5 dual 2.0 running OS 10.4.2…I have been running everything on the AJA 10bit Uncompressed codec until now and it has run perfectly. I have redigitized everything in DV NTSC and am working ‘offline’ on a DV project/timeline. For some reason my firewire is acting up and it won’t output the DV signal to my deck. I tried refreshing the external devices, but this seems to only result in glitchy video and then it eventually cuts out. My external video is set to ‘all frames.’ Any ideas? Can I view external video thru the Kona card while working in DV?

    Jeremy Garchow replied 21 years ago 3 Members · 3 Replies
  • 3 Replies
  • Walter Biscardi

    September 12, 2005 at 2:41 pm

    [easycompany] “Can I view external video thru the Kona card while working in DV?”

    I’m pretty sure you can as I do this with the Kona 2. Use the DV Easy Setup and then change your Audio / Video Playback to the Kona card.

    As for the Firewire port, do you have any other video sources other than the deck attached to it? I don’t have any problems here with the Firewire outputs and my Kona 2.

    Walter Biscardi, Jr.
    Creative Genius, Biscardi Creative Media
    https://www.biscardicreative.com

    Now in Production, “The Rough Cut,” https://www.theroughcutmovie.com

    Now editing “Good Eats” in HD for the Food Network

    “I reject your reality and substitute my own!” – Adam Savage, Mythbusters

  • Easycompany

    September 12, 2005 at 6:04 pm

    Thanks Walter. I am having the same problem with my other FCP (5.0.2) system which is DV only. The fire wire ports work because my fire wire drive is running fine on the same ports. The camera i’m running into it works on my laptop and video comes out fine. Is this a tiger/fcp 5 glitch? should i consider getting a new firewire pci card?

  • Jeremy Garchow

    September 12, 2005 at 7:00 pm

    Yes, you can, but you have to choose to monitor the Kona or your DV deck. If you use the FCP DV easy set up your firewire ports should be active with the FCP dv signal, if you choose to monitor using the Kona 8 bit to dv easy set up, your kona card will be active and you can monitor that way.

    If you have recently upgraded to Tiger and did not do a clean install, check this article:

    https://docs.info.apple.com/article.html?artnum=301852

    This might be your problem as well.

    Jeremy

    ———–
    G5 Dual 2Ghz <> 4GB RAM <> FCP 5.02 <> Kona 2

    ATTO 42XS <> Huge Systems 1.25 TB 4105 Fibre

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy