• Blackmagic Design

  Blackmagic analague audio capture for V/O

  Posted by Neil Donoghue on October 12, 2008 at 6:11 pm

  Hi,
  I have been trying to setup a vo mic for an editor using blackmagic in a FCP OS 10.4…
  I have a desk with mic taking the op of the desk to the BM deck in left…
  I cannot get a signal in and I have played around with the settings Im no expert but I can figure these things out usually mmm..
  I saw somewhere that the audio signal must have a video reference along with it to work…
  Is this correct? This could be my solution..
  I have to go in here tmrw and make this happen…

  Any ideas???

  Thanks a mill,

  Neil

  Neil Donoghue replied 17 years, 10 months ago 2 Members · 2 Replies
• 2 Replies

• 

  Margus Voll

  October 13, 2008 at 9:43 pm

  Hi.

  Just “few seconds” ago there has been a thread of that and if you make a search you will probably have multiple times the same question 😉

  https://forums.creativecow.net/readpost/124/869592

  —

  Margus

  https://iconstudios.eu
• 

  Neil Donoghue

  October 22, 2008 at 6:48 pm

  Hey Margus,
  Thanks for you help..I sorted it out by using the apple audio input from an aux output of the desk…
  I have to use aux as the desk is monitoring the output of the blackmagic with its monitor outs to speakers.
  I could not get an analogue audio signal into the blackmagic card after trying everything..
  Thanks,
  Neil

Reply to this Discussion! Login or Sign Up