• Blackmagic Design

  “No Video Input” Decklink HD Pro Dual PCI-X

  Posted by Jan Schulz on June 27, 2006 at 11:28 am

  Hi,

  i just replaced a Decklink Pro with a Decklink HD Pro Dual Link. SDI and analog outputs are fine.
  The Problem is: I get neither HDSDI nor SD-SDI input at all.

  Yes, i uninstalled the previous driver. The card sits in the 133 Mhz slot and the problem occurs in FCP and
  the BM Deckcontrol-Tool using any easy setup.

  I tried different cables and connecting the deck (Sony JH-3) directly to an HD-Link to veriy it is outputting correctly.
  It is.

  Driver is version 5.6

  Any ideas, Gentlemen?

  Manuel Deo replied 19 years, 10 months ago 2 Members · 3 Replies
• 3 Replies

• 

  Manuel Deo

  June 27, 2006 at 4:37 pm

  Hi Jan,

  Infortunatly, i have the same problem like you.

  I have the logo “no video input” in my decklink overlay.

  So i can’t help you, but my system has 4 gb of ram, and i have read this :

  https://blackmagic-design.com/support/detail.asp?techID=160

  I try to take off 2 Gb.

  I do this test and i tell you if something good happens
• 

  Jan Schulz

  June 29, 2006 at 9:46 am

  Solved my problem by putting the decklink in the middle pci-x slot.
  Now I have 1 seritek sata card in the lower and one in the upper slot.
  I know this is not recommended since the lower and the middle slot might slow each other down.
  Seems to work though.
  I can caputre 1080 50i 8Bit (haven’t tried 10bit yet) and both of my sata arrays operate at about 250 MB/s.

  Wish youd good luck with getting yours to work!
• 

  Manuel Deo

  June 30, 2006 at 3:02 pm

  hi Jan,

  unfortunality, i have try to put the decklink in another pci x slot ,but always the same no video input.

  Thanks for your help,
  maybe to morrow is a better day

  manuel

Reply to this Discussion! Login or Sign Up