[Julian Masters]

Dropbox link sent.
Good luck.

[Julian Masters]

Don’t forget to do them incrementally one at a time.

[Julian Masters]

No problem Igor.
You only need to use the 1.10 if you intend to update it further.
I’ve also added 1.26 and 1.30 (which I hadn’t seen before) to dropbox.
1.26 improves the error processing on SXS cards, while 1.30 just looks it adds XQD memory card support, which you may not need.

Julian.

[Julian Masters]

Dropbox link sent.
Remember if you get back to 1.05 and do the update, then 1.10 doesn’t seem to do much (it still says 1.05 afterwards). However without doing it I have had problems.
Also, as far as I’m aware the latest firmware is 1.25, unless 1.30 has just been released.
Good luck.
Julian.

[Julian Masters]

Hi Benamir.
I did reply to you the following day (and again about a week ago) but my posts didn’t seem to get through the moderators.
If you let me know your email address then I can invite you to Dropbox.
Regards,
Julian.

[Julian Masters]

Hi Panagiotis.
I’ve sent you a Dropbox link containing all the files.
You should hopefully be able to go back to 1.05, and then go up one at a time.
1.10 goes through very quickly without any errors, but afterwards it still says the camera is on 1.05
I started to bypass that version, but I’ve recently found a couple of cameras that wouldn’t upgrade to 1.11 correctly unless I had flashed 1.10, so I recommend using it.
I assume it does a minor upgrade to one of the “modules” inside.

Good luck.

Julian.

[Julian Masters]

I don’t know whether you’ve done the upgrade successfully, but I’ve just tried upgrading a camera that was on 1.02. It went to 1.05 ok, but aborted on 91% when going to 1.11
So I reflashed 1.05 again.
I have got a version of 1.10 which I’ve used before. However it flashes very quickly but stays on 1.05 afterwards (with no error messages during the flash). IIRC i had a camera a while ago that wouldn’t go to 1.11, but when I flashed the 1.10 it then went on to 1.11 and upwards.
So I tried using 1.10, and it then enabled me to go all the way on to 1.26

I’ve added 1.10 to the dropbox folder just in case you have a similar problem.

Julian.

[Julian Masters]

You have to do the upgrades incrementally i.e. one after the other.
The Sony site I believe only has the latest version.

Another poster had the same problem (…. follow my link in this thread from Feb 28).
You should be able to reload v1.05, and then go up in stages.

Good luck.

[Julian Masters]

Link sent.

[Julian Masters]

Hi Andy.
You should hopefully get a Dropbox email linking to the files.

Good luck with the upgrade.