-
Online/Offline editing
When I try to recapture my footage at full resolution in the online phase, I keep getting this message: Batch Capture: Timecode Error: Unable to locate the specified timecode. You may have specified a timecode with insufficient room for a pre/post roll operation. Can anyone tell me how to get past this problem? Thanks in advance for your help.
-
2 Replies
-
There are two times when I see this warning normally:
1. When the tape is cued to a place where no timecode is recorded (often the very end of the tape). For this, just rewind the tape until there is video.
2. When the tape was digitized within 3 seconds of the start of the tape. This doesn’t give enough room for the 3 second pre-roll. It seems like there is a way to change this, but I don’t know how.
There is also the possibility that some sequence settings or cables are set up right.
Hope that helps.
-Russ
-
To change preroll you have to go to Audio/Video Settings – Device Control Presets then edit the preset you are using. It would be a good idea to duplicate the preset you are using and edit the duplicate.
Also make sure you are batching the right tape.
Reply to this Discussion! Login or Sign Up