• Apple Final Cut Pro Legacy

  DSR-1800 hook-up/system settings

  Posted by L Isha on April 29, 2005 at 11:12 pm

  Hello to all,

  I rented a DSR-1800 and I am outputting via firewire. Once I’ve outputted to tape, the audio mixer is going to do an audio lay-back using the same deck. I disconnected my DSR-11 and connected the DSR-1800 via firewire.

  I am reading the manual, but if anyone can give me a crash course on setting this deck up (FCP settings, how to set TC so I can black and code a tape, or anything you can think of…) it would be greatly appreciated!

  I tried doing a quick test and I have deck control via firewire and I was able to capture.

  However, when I attempted to print to video the following message appeared.

  “The selected audio and video devices do not match.
  -Apple Firewire NTSC (720×480)
  -Built-In Audio

  Please verify that the audio and video outputs are externally routed to the intended devices.

  Do you want to proceed?”

  What does this mean? And what should I do?

  Thanks so much!
  Lisha

  Shane Ross replied 21 years ago 2 Members · 4 Replies
• 4 Replies

• 

  Shane Ross

  April 29, 2005 at 11:21 pm

  My question is, if you are outputting via firewire, why did you chose a DSR-1800 over a DSR-11? The DSR-11 can take an output, and even work with your timeline TC:

  https://discussions.info.apple.com/webx?14@612.6aKwaoVBQhe.79335@.689a002d

  I only use the 1800 when outputting via component cables, so I am no help there.
• 

  L Isha

  April 29, 2005 at 11:36 pm

  I rented it so the audio mixer could do an audio lay-back AND I thought I needed to use it to output because I did not know I could use the DSR-11 to stripe a tape. I just read the article you referenced. I am going to read it again, download the software and give it a try. I need to output tonight and I am getting a little frantic! 🙂

  Thanks so much!!!!
• 

  L Isha

  April 29, 2005 at 11:45 pm

  This project is for broadcast. Usually I record directly from my timeline. Will converting to a Quicktime movie and exporting into Simple Video Out affect the quality? Will the Quality Control guys give me a hard time?

  Lisha
• 

  Shane Ross

  April 30, 2005 at 12:49 am

  Don’t use SimpleVideoOut to output the whole show. Use it to start the tape stripe…only black and record up to 1;01;00;00. Then you switch the deck TC settings to INT REGEN and Edit to Tape…from FCP.

  Follow those instructions to a “T”

Reply to this Discussion! Login or Sign Up