• Avid Media Composer

  Avid MC 3.1.2 with avid mojo / macbook pro

  Posted by Leo Scott on May 14, 2009 at 11:51 pm

  Hi
  I have been working with Media Composer 3.1.2 on a macbook pro os version 10.5.5 for several months with any problems. However I just bought an analogue mojo second hand and can’t seem to make it be recognised by MC. I have tried powering everything down and rebooting but I still get the message, ‘no avid dna detected’. I have connected the mojo to the macbook with a firewire 400 and have no other drives attached. Is this a firmware issue?
  Any suggestions much appreciated.
  Leo

  Raúl Villarán replied 17 years, 2 months ago 2 Members · 1 Reply
• 1 Reply

• 

  Raúl Villarán

  June 19, 2009 at 1:19 pm

  Hi,
  I use a AVID Mojo long, Since 2005, I have it connected to an hp nw8440, Workstation is a laptop and I am doing very well, My version of Media Composer 3 and recognizes it very well.
  Make sure that the light "host" on this, If it is not, The following faults can be the following:
  1.Not properly connected the firewire cable 6 pin – 4 pin
  2.Firewire card or port is not omologado by AVID (visit AVID and see Las compatilidades)
  3.The Mojo this broken, As I spend a year and buy some light not lit the "host", Cost me € 480 and the blessed relief.

  Also tell you to be careful with the firewire cable you use, Who is the original Mojo or to try several, I also move that I was recognized with some, And AVID recommends that the cable does not exceed more than 1,5 meters.

  Greetings, I hope that is not what you bought defective.

Reply to this Discussion! Login or Sign Up