You bet! Best of luck!

We use a lot of little adapters/converters like that. Also just remember that your SDI connections are SD-SDI not HDSDI

Well 720p is 1280×720 your correct in resolution that was my fault. NTSC is 640×480. Idk why 720 stuck out at me. Yeah. If you send it a composite signal the yellow line of rca from and video outputting device you’d be able to get a clear picture. That’s where the problem lies unfortunately. Getting the right signal to input into it.

Sure thing. I used to have a t2i and I believe it came with a composite output adapter. Could always try that as well. I don’t remember if the hdmi signal will drop that low. Also in the canon realm of things, look up magic lantern firmware for the camera. Opens up a wide range of options.

Peter,

I haven’t used the mx70 for a few years once we switched to the ATEM platform. However, a lot of issues that I ran across with component or any signal was that we had to run signals through a scan converter. We used a Sony 1024. This allowed us to recook the digital signal to one the mx70 could see and use. I actually only used component i…

Read more