Ok, you were right. Thanks!

Brilliant! So easy! I knew there had to be a way. Many thanks!

Thanks for your response. I need to move the layers back to frame 0 because I want the keyframes within those Layer PreComps to all line up in order to tweak them. Once I change the keyframes within those Layer PreComps, I’ll sequence the layers again. I hope that makes sense.

Hi All,

I have 20 sequenced layers (offset by 2 frames each). I have flowers ‘blooming’ sequentially across the screen. I would like to reset the inpoint of my sequenced layers, so that they go from offset by 2 frames each, to all starting at zero again. Is there a trick or a script that will do this? Thanks!

Hi Y’all, I’ve got my render queue setup to render 4 C4D projects. I need to send all of these to a render farm. Do I need to export or save the Render Queue, or will it be included when any of these C4D files are opened?

I’m working on a project that has 220 GB of pre-rendered movies, that aren’t doing much. This project still runs very slowly, and takes a lot of time to render. Is it faster to just dissolve between layers, and use whatever warping effects instead of pre-rendering so many huge .mov files?

Hi Y’all, I want to parent to a layer that is already animated, but halfway through the animation. It would be great if there was a way to keyframe the parent on/off. I haven’t seen a way to do it other than to buy the Parental Controls script, but I’m not sure if that would even do it.

Hi All, what would be the best method for tweaking individual frames after the rotobrush frames have been frozen?

Thanks!